INFITECH Standard Spray Booth IT-1101
DESIGN STANDARD:
BS EN 13355: 2004 + A1: 2009
BS EN 60204: 2006 + A1: 2009
BOOTH DIMENSIONS:
Internal dimensions: 7000 X 4000 X 2800mm (L X W X H)
External dimensions: 7110 X 5760 X 3810mm (L X W X H)
Entrance door: 3400 X 2700 mm (W X H)
Personel door: 800 X 2000 mm (W X H)
BOOTH: Wall panel: 50mm dual-skin insulated panels filled with heat resistant rock wool
Basement: Galvanized sheet bending forming, full grids, 350mm high, can be adjustable
Ramps: 3 pieces; 2000 X 1030 X 320mm, diamond structure
INTAKE & EXHAUST SYSTEM:
Intake fan: Direct-type turbine fan, 11KW, 970rpm, 380V, 50Hz, SIEMENS motor, 35,000 m3/h, 600pa
Exhaust fan: Direct-type turbine fan, 11KW, 970rpm, 380V, 50Hz, SIEMENS motor, 35,000 m3/h, 600pa
Empty loaded air speed: 0.35m/s, noise < 78db
With 1 piece of manual damper, and 1 piece of electric damper
LIGHTING SYSTEM:
Ceiling lighting: 8 sets of light fixtures, each 6 X18W, 864W total
Sidewall lighting: 8 sets of light fixtures, each 4 X 18W, 576W total
Protection grade IP55, brightness > 1500lux
HEATING SYSTEM: Heat exchanger material: Stainless steel 1Gr18Ni9Ti(SUS304)
Heat exchanger power: 315kw T temperature increase capability: 25° C (from -5°C to 20°C in painting phase)
Max. working temperature: 80°C
Heating time: 5-8 minutes (from 20°C to 60°C in baking phase)
Burner model: RIELLO diesel burner RL-34-2
CONTROL SYSTEM: Implementation standards: standard Y/Δ step-down start control system
PLC controller: Yes, PLC control, more reliable and lower breakdown rate
Pressure testing: The pressure gauge indicates the pressure inside the booth.
Features: painting, heating painting, flash-off, baking, lighting, emergency stop switch, failure indication, over-temperature alarm indication, baking delay stop protection, motor over-load and over-current protection, fan and heating system interlock
